Sportsmith Blog
17Jul/18Off

How to Re-calibrate Keiser M3 Indoor Cycle Display With No Tool

This video demonstrates how to re-calibrate the Keiser M3 indoor cycle display without a calibration tool.

To begin move the handle to the straight up position

  • Unplug the battery connector from the display
  • Wait several seconds before reconnecting
  • Wait for the computer to go blank
    • This will take one to two minutes
  • Turn the pedals forward one revolution
    • At this point you should see some numbers flashing
  • Move the handle all the way to the down position
  • Turn the pedals forward one revolution
    • Now the display should show a "1"
  • Twist and release the magnet housing five times to save the calibration and exit calibration mode
  • "CAL'b" indicates a successful calibration, you can resume normal use of your indoor cycle after the computer goes blank
  • "Err2" indicates the handle was too far forward
    • Try again with the handle straight up as shown in the video
  • Err1 indicates the handle was too far down
    • Try again with the handle straight up as shown in the video

 

For additional information please visit: Keiser partsĀ 

Comments

comments

Comments (0) Trackbacks (0)

Sorry, the comment form is closed at this time.

No trackbacks yet.